10/100Base-TX Hardened PoL/PoE Ethernet Extender
User’s Manual
13
Installation
This chapter gives step-by-step installation instructions for the Hardened
Ethernet Extender.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment where it will not
be subjected to extreme temperatures, humidity, or electromagnetic
interference. Specifically, the site you select should meet the following
requirements:
∞
The Surrounding Air temperature should be between -40 to +167 degrees Fahrenheit
(-40 to +75 degrees Celsius).
∞
The relative humidity should be less than 95 percent, non-condensing.
∞
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards.
∞
Make sure that the equipment receives adequate ventilation. Do not block the
ventilation holes of the equipment.
∞
The power outlet should be within 6 feet (1.8 meters) of the product.
DIN Rail Mounting
Fix the DIN rail attachment plate to the back panel of the Hardened Ethernet
Extender.
Installation: Place the Hardened Ethernet Extender on the DIN rail from
above using the slot. Push the front of the Hardened Ethernet Extender
toward the mounting surface until it audibly snaps into place.
Removal: Pull out the lower edge and then remove the Hardened Ethernet
Extender from the DIN rail.
