25
CHAPTER 5: Operation
5. Operation
After you’ve pre-checked your USB equipment and
verified that it works when everything’s directly
connected (see the Note at the start of
Section 4.1
),
then configured your Modules and installed everything,
you’re ready to power up the system. (At this point, the
X-Tender’s Remote Module should be plugged in and
powered ON, but all devices attached to the X-Tender
should be powered OFF.)
1. Turn ON the host computer attached to the Host-
Interface Module.
2. Turn ON any powered peripherals attached to the
Device-Interface Module.
The computer should detect the USB peripherals and
the system should then operate transparently, just as if
the X-Tender weren’t even there. If you have any
problems, see
Chapter 6.
