Black Box AVSC-7DA-HDMI, Руководство пользователя, Страница: 5 / 48

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com
Page 5
Safety Information
Safety Information
1. Save the carton and packing materials whether or not the unit arrives in good condition. If you ever need to ship the unit, use
the original factory packing.
2. Read all documentation before operating your equipment. Retain all documentation for future reference.
3. Follow all instructions printed on the unit chassis for proper operation.
4. Do not spill water or other liquids into or on the unit, or operate the unit in liquid.
5. Make sure power outlets conform to the power requirements listed on the back of the unit.
6. Do not use the unit if the electrical power cord is frayed or broken. Route the power supply cords so that they are not likely
to be walked on or pinched by items placed upon or against them. Pay particular attention to cords, plugs, convenience
receptacles, and the points where they exit from the appliance.
7. Always operate the unit with the AC ground wire connected to the electrical system ground. Be careful not to defeat the
grounding of a piece of equipment.
8. Voltage must be the same as that printed on the rear of the unit. Damage caused by connection to improper AC voltage is
not covered by warranty.
9. Power off and disconnect the unit from the voltage before connecting any equipment.
10. Do not leave the unit on unstable surfaces.
11. Do not use the unit near stoves, heat registers, radiators, or other heat-producing devices.
12. Do not block the fan intake or exhaust ports. Do not operate the equipment on a surface or in an environment that may
impede the normal flow of air around the unit, such as a bed, rug, carpet, or completely enclosed rack. If the unit is used in
extremely dusty or smoky environment, the unit should be periodically “blown free” of foreign matter.
13. Do not remove the cover. Removing the cover will expose you to potentially dangerous voltages. There are no user-serviceable
parts inside.
14. Do not drive the inputs with a signal level greater than that required to drive the equipment to reach full output.
15. When you are not using the unit, unplug the power cord of the equipment from the outlet.
16. Refer servicing to qualified service personnel when:
A. The power supply cord or the plug is damaged.
B. Liquid has been spilled into the equipment.
C. The equipment has fallen.
D. The equipment has been exposed to rain.
E. The equipment does not appear to operate normally, or exhibits a change in performance.
F. The equipment has been dropped, or the enclosure damaged.