Black Box ACU1007A, Руководство пользователя

Страница: 27 / 38

26
SERVSWITCH™ BRAND PS/2 MICRO EXTENDER
5.3 Finishing Your Installation
To finish installing your Extender system after attaching devices to it as described
in
Section 5.2 , take these steps:
1. Attach the output cord of the Remote Unit’s power supply to the Unit’s
power jack. Then plug the IEC 320 end of the power supply’s input cord into
the IEC 320 inlet on the power supply’s transformer. Finally, plug the other
end of the input cord into a utility (mains) power outlet. The Remote Unit
should power up immediately; it has no ON/OFF switch. (If the Remote Unit
is in the location you want it to be, you can leave it plugged in and powered
up more or less indefinitely.)
2. If you have a KVM switch attached to the Remote Unit, power it ON.
3. Interconnect the Local and Remote Units by running CAT5 cable between
their right-side-mounted modular jacks (the ones labeled “Interconnect”).
Refer to the guidelines for this cable in
Section 4.2.5 .
4. Power ON the PC CPU or KVM switch attached to the Local Unit’s CPU port.
If the CPU or switch provides enough DC voltage on its keyboard port/leads,
the Local Unit will begin operating immediately; like the Remote Unit, it has
no ON/OFF switch.
5. Make sure that the remote keyboard and mouse both function properly. (If
your PC normally boots up in DOS, you will need to run Windows or some
application that supports the mouse.)
If everything works in your test setup, repeat the above steps for your actual
installation. If everything works in the actual installation, your ServSwitch™ Brand
CAT5 PS/2 Micro Extender system should be ready for continuous operation.