CHAPTER 5: OPERATION
Installation (continued)
5.
Plug the output cord of the
Ultimate Pro’s
power cable
into the DC IN jack on the
Ultimate Pro
. Plug the USB or
PS/2 keyboard connector into the corresponding port on
the PC. Macintosh users must use the USB power cable.
6.
Insert (2) AAA batteries into the remote control.
7.
Turn on the computer.
8.
Turn on your TV, VCR, etc. If necessary, select VIDEO IN
(or S-VIDEO IN, COMPONENT IN or RGBS VIDEO IN) as
the receiving device’s video input source. If you’re
unsure how this is done, consult the Owner’s Manual for
the receiving device.
NOTE
Some portable computers require that the VGA output be
activated for the external VGA port to function. If the
Ultimate
Pro
is connected correctly and you have a picture on the
receiving TV or projector, this may be the cause. Consult the
User’s Guide that came with your computer if you’re unsure
how this is accomplished. The portable computer’s LCD display
may need to be de-activated with this procedure.
4. Operation
z
HORIZONTAL / VERTICAL position adjustments
Indicated by arrows on the side of the
Ultimate Pro
z
MENU Button
Accesses the on screen display for adjusting Horizontal and
Vertical size, Brightness, Contrast, Hue, Saturation, Flicker,
OSD color and Reset.
z
PAL/NTSC
Toggle between each of the output video standards
z
FINE TUNE
Flicker adjustment
z
SAVE
Saves current settings for use between power-ups, etc.
z
ZOOM button
Toggle between Zoom and Normal display
_ _________________________________________________________
10
VGA to VIDEO Ultimate Pro
3.3 Installation Procedures
Take these steps to install your
Ultimate Pro
:
1.
Turn off your computer.
2.
Plug the supplied VGA Y-cable (the end with the Y-
connection) into your computer’s VGA output and the other
end into the VGA IN/OUT of the
Ultimate Pro.
The ends of
the cable are labeled to specify how to connect them.
3.
If using a local monitor plug the monitor’s VGA cable into the
short end of the Y-cable.
4A. If using the
composite video output
, plug one end of the
included composite video cable into the
Ultimate Pro’s
VIDEO OUT and the other end into the VIDEO IN on your TV,
VCR, etc. Make sure the output switch is set to CVBS.
4B. If using the higher quality
S-video video output
, plug one
end of the included S-Video video cable into the
Ultimate
Pro’s
S-VIDEO OUT and the other end into the S-VIDEO IN
on your TV, VCR, etc. Make sure the output switch is set to
CVBS.
4C. If using the
RGBS video output
, plug the DB9 end of an
RGBS cable (not included) into the
Ultimate Pro’s
RGB
VIDEO OUT. If the other end of this cable is a SCART
connector, plug it into the SCART connector of your TV,
VCR, etc. If, however, the other end of this cable has four
BNC connectors, plug them into the RED, GREEN, BLUE, and
SYNC connectors of the RGBS VIDEO IN port of your TV,
VCR, etc. If you need an RGBS cable, contact your supplier
for technical assistance. Make sure the output switch is set
to RGB.
4D. If using the
component (Y.Cb.Cr) video output,
connect the
included component video cable in the
Ultimate Pro’s
Y.Cb.Cr
output and the other ends into the component video input of
the video display. The cable and the plugs are color-coded
for proper connection. Make sure the output switch is set to
Y.Cb.Cr.
9
__________________________________________________