4
Charge until the Battery Status LED Indicator red LED flashes (approximately 12-14 hours). DO NOT
CHARGE FOR LONGER THAN 14 HOURS.
Charging/Recharging Using the 12 Volt DC Charging Adapter
Plug the barrel tip of the supplied 12 Volt DC Charging Adapter into the 12 Volt DC Charging Port.
Insert the 12 volt DC plug end into the accessory outlet of your vehicle or other 12 volt DC power source.
Make sure the Spotlight is OFF (the Trigger Lock is in the OFF position and the Trigger is not depressed).
Charge until the Battery Status LED Indicator red LED flashes (approximately 12-14 hours). DO NOT
CHARGE FOR LONGER THAN 14 HOURS.
Make sure the DC source (jump-starter, battery pack, vehicle accessory outlet, etc.) is 12 volt DC
and is able to supply at least one half amp at 12 volt DC for 8 hours. This means a battery pack
should be charged with at least 4 amp hours capacity.
Note:
When using a vehicle’s 12 volt DC accessory outlet as a charging source, be aware that some
vehicles require you to turn on the ignition to power the accessory outlet.
WARNING:
NEVER ATTEMPT TO USE THE AC CHARGER AND DC CHARGING PORT SIMULTANEOUSLY.
OPERATING INSTRUCTIONS
To turn the Spotlight ON, depress the Trigger. To lock the
Trigger in the ON position, depress the Trigger, then slide
the Trigger Lock up. The spotlight will stay on until the
lock is moved to the OFF position and the trigger is
released.
CARE AND MAINTENANCE
All batteries lose charge with time, especially when they are warm. Recharge the unit every two
months when not in frequent use, preferably using the 120 volt AC method.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit
with a soft cloth moistened with a mild solution of water and detergent.
The quartz halogen bulb is the only user-replaceable part in the Spotlight. Periodically inspect the
condition of adapters, connectors and wires. Contact Technical Support toll-free at 1-800-544-6986 to
replace any components that have become worn or broken.
Spotlight Bulb Replacement
To replace the bulb, you will need a small Phillips screwdriver and a 6 volt H3 55 watt replacement bulb.
During installation, avoid touching the glass part of the bulb. Bulb life may be shortened by installing a
bulb with dirt or fingerprints on it. The bulb can be wiped clean with a cloth moistened with alcohol.
12 VOLT DC CHARGING
PORT
12 VOLT DC CHARGING ADAPTER
RETAINING RING
RUBBER
“O” RING
REFLECTOR
RUBBER
END CAP
RUBBER BEZEL COVER
TRIGGER LOCK
TRIGGER
SWITCH
QUARTZ HALOGEN
BULB
TRIGGER
TRIGGER LOCK
SL102B_ManualEN_051007.qxp 5/10/07 9:13 AM Page 4
