1
2
SPECIAL INSTRUCTIONS
❑
To avoid a circuit overload, do not operate another high-wattage appliance
on the same circuit.
❑
If an extension cord is absolutely necessary, a 10-ampere and 120-volt,
or 6-ampere and 220-volt cord should be used. Cords rated for less amperage
may overheat. Care should be taken to arrange the cord so that it cannot be
pulled or tripped over.
SAVE THESE INSTRUCTIONS.
IMPORTANT DOWNY WRINKLE RELEASER® LIQUID INSTRUCTIONS
1. The physiological effects of the operation of the Downy Wrinkle Releaser® liquid,
beneficial or otherwise, have not been investigated by Underwriters Laboratories Inc.
2. First aid measures –
a. Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes.
If irritation occurs or persists, have eyes examined or treated by medical personnel.
b. Skin Contact: Remove contaminated clothing and footwear. Wash material off skin
with plenty of soap and water. Wash clothing and footwear before reuse.
c. Ingestion: Drink milk or water to dilute. Induce vomiting only if advised
by physician or poison control center. Contact physician or poison control center.
3. Personal precaution –
a. Avoid prolonged exposure.
b. Use rubber or neoprene, when needed, to prevent skin contact.
c. Use safety glasses recommended for handling spills.
4. Care and storage – Store in a cool, dry place. In poorly ventilated areas, solvent fumes
may be irritating. Masks rated for ammonia or organic solvents may be desirable. Make
sure you have good ventilation when handling liquid spills.
5. Disposal Considerations – Disposal of this Downy Wrinkle Releaser® liquid must be
in accordance with local, state and federal regulations.
IMPORTANT SAFETY
INSTRUCTIONS
When using your iron, basic safety precautions should always be followed, including
the following:
❑
READ ALL INSTRUCTIONS BEFORE USING.
❑
Use iron only for its intended use.
❑
To protect against a risk of electric shock, do not immerse the iron in water
or other liquid.
❑
The iron should always be turned off (refer to "How to Use" section) before
plugging into or unplugging from an outlet. Never yank cord to disconnect from
outlet; instead grasp plug and pull to disconnect.
❑
Do not allow cord to touch hot surfaces. Let iron cool completely before putting
away. Loop cord loosely around cord wrap when storing.
❑
Always disconnect iron from electrical outlet when filling with or emptying
of water, and when not in use.
❑
Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble the iron,
take it to a qualified serviceman for examination and repair. Or, call the appropriate
toll-free number listed on the cover of this manual. Incorrect reassembly can cause
a risk of electric shock when the iron is used.
❑
Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board. Always position iron carefully to prevent it from falling if ironing board
is accidentally moved or cord is pulled. Always use heel rest.
❑
Burns can occur from touching hot metal parts, hot water, or steam. Use
caution when you turn a steam iron upside down or use the surge of steam —
there may be hot water in the water tank. Avoid rapid movement of iron to
minimize hot water spillage.
PI9000Pub1000001842R1 8/9/05 10:47 AM Page 2
