Black & Decker NW4820SPT-B2C, Инструкция по эксплуатации

Страница: 9 / 14

ENGLISH • 9
Labels on tool
The label on your tool may include the following symbols:
FEATURES (Fig. A and B)
1. On/off switch
2. Bowl release button
3. Dust bowl
4. Charger
5. Charging bracket
6. Wet/Dry foam insert
7. Wet/Dry deflector
8. Squeegee
ASSEMBLY
Wall mounting
The product can be attached to a wall to provide a
convenient storage and charging point for the appliance.
When fixing to a wall, make sure that the fixing method is
suitable for the wall type and is appropriate to the weight of
the appliance. To wall mount the vac, refer to Fig. C.
f
Mark the location of the screw holes (within reach
of an electrical outlet for charging the vac while it is
on the wall bracket).
f
Fix the mounting bracket to the wall using appropriate
scres and plugs for the type of wall and weight of
the appliance.
f
Hang the appliance on the wall by placing the opening
on the base of the vac over the hooks in the wall
mount charging bracket.
Accessories (Fig .B)
These model is supplied with a squeege tool (8) for wet
use on hard surfaces.
Fitting (Fig. D)
f
Insert the appropriate accessory into the front of
the appliance. Make sure that the accessory is
pushed fully in.
USE
f
Before first use, the battery must be charged
for at least 24 hours.
f
Place the appliance on the charging bracket
whenever it is not in use.
Warning! Before charging, be sure to empty all liquid
contents and dry thoroughly, to avoid damage to your
appliance.
Charging the battery (Fig. C)
f
Make sure that the appliance is switched off.
The battery will not be charged with the on/off switch
in the on position.
f
Place the appliance on the charging bracket (5).
f
Plug in the charger. Switch on at the mains.
f
Leave the appliance to charge for at least 21 hours.
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely.
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Switching on and off (Fig. E)
f
To switch the appliance on, slide the on/off switch (1)
forward to position 1.
f
To switch the appliance off, slide the on/off switch (1)
back to position 0.
Dry pick-up
f
For everyday spills of dry material.
Wet and dry pick-up
f
For everyday spills of dry material, use your appliance
without the squeegee accessory.
Caution! Your product is designed for light spills only.
f
This vacuum can also be used to pick up everyday
liquid spills. Use the squeegee accessory on non-
absorbent, hard surfaces. On absorbent surfaces,
such as carpet, your appliance will pick up wet spills
better without the accessory.
f
For best performance on hard surface wet pickups,
insert squeegee into the bowl nozzle opening.
f
For best results when using this accessory, hold
the appliance at an angle of 45° and pull it slowly
towards you.
f
Do not fill the bowl beyond the end of the intake chute.
If there is any liquid in the bowl, do not turn the unit
upside down, sideways, point the nozzle upward,
or shake the vac excessively.
f
After picking up liquid substances clean the vac
and filter immediately. Mold and mildew may form if
the unit is not properly cleaned after wet pickups.
f
Before charging, be sure to empty all liquid contents
and dry thoroughly, to avoid damage to your appliance.
Read
Instructions
Manual
Use Eye
Protection
Use Ear
Protection
V ........ Volts
A ........ Amperes
Hz ....... Hertz
W ........ Watts
min ..... minutes
..... Alternating
Current
..... Direct
Current
n
0
....... No-Load
Speed
...... Class II
Construction
.... Earthing
Terminal
.... Safety Alert
Symbol
.../min.. Revolutions
or Recipro-
cation per
minute