Black & Decker KG900, Руководство пользователя

Страница: 9 / 88

9
E N G L I S H
◆
The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs.
Attach the wires to their respective points in
the plug (see above). Brown is for Live (L) (2),
blue is for Neutral (N) (4).
◆
Before replacing the top cover of the mains
plug ensure that the cable restraint (3) is
holding the outer sheath of the cable firmly
and that the leads are correctly fixed at the
terminal screws.
◆
If the plug has a fuse cover, make sure that the
fuse cover is fitted. Do not use the plug if the
fuse cover is missing or damaged.
Never use a light socket.
Using an extension cable
Always use an approved extension cable suitable
for the power input of this tool (see technical
data). Before use, inspect the extension cable for
signs of damage, wear and ageing. Replace the
extension cable if damaged or defective.
When using a cable reel, always unwind the cable
completely. Use of an extension cable not suitable
for the power input of the tool or which is damaged
or defective may result in a risk of fire and electric
shock.
PACKAGE CONTENTS
The package contains:
1 Angle grinder
1 Side handle
1 Grinding or cutting disc
1 Flange set
1 Two-pin spanner
1 Instruction manual
◆
Carefully unpack all parts.
◆
Please note that additional items may be found
in the package, depending on the letter suffix
following the catalogue number of your tool.
OVERVIEW (fig. A)
1. On/off switch
2. Side handle
3. Spindle lock
4. Guard
5. Grinding or cutting disc
ASSEMBLY
Before attempting any of the following
operations, make sure that the tool is
switched off and unplugged and that the
disc has stopped rotating.
Removing and refitting of the guard
Never use the tool without the guard,
except when sanding.
Removing (fig. B)
This tool is fitted with a guard. For sanding only,
you can remove the guard as follows.
◆
Remove the outer flange, disc and inner flange
as described below.
◆
Use a screwdriver to remove the screws (6).
◆
Remove the flange (7), guard (4) and spring
washer (8). Store these parts carefully.
Refitting (fig. C)
◆
Place the tool on a table, with the spindle (9)
facing up.
◆
Place the spring washer (8) over the spindle
and locate it on the shoulder (10).
◆
Place the guard onto the tool as shown.
◆
Place the flange (11) over the spindle with the
protruding pips towards the guard. Make sure
that the holes in the flange align with the screw
holes.
◆
Secure the flange with the screws (6). Make sure
that the screws are fully tight and that the guard
can be rotated.
Fitting the side handle (fig. A)
Always use the side handle.
◆
Screw the side handle (2) into one of the
mounting holes in the tool.