Black & Decker BXAC40008GB, Руководство пользователя

Страница: 12 / 16

ENGLISH
(Original instructions)
12
While the unit is operating, water will be extracted
from the air into the built-in water tank.
When the reservoir is full, both the compressor and
motor will stop, the unit will emit a buzzing sound and
the ‘Water’ and ‘Comp’ indicator on the unit’s control
panel will begin to flash.
When this occurs, we recommend you drain or
empty the water tank, to ensure the unit continues to
operate correctly.
To empty the water tank, follow the steps
below:
♦
Turn off the unit and avoid moving it.
♦
Place a container, such as a water tray,
underneath the drain hole.
♦
Remove the drain plug and plug cap, to allow the
water to drain out.
♦
When the container is almost full, place the drain
plug back into the plug hole and empty the water
tray.
♦
Repeat this procedure until the unit is empty.
♦
Once you have emptied the unit, put the rubber
plug and plug cap back into place and tighten the
cap firmly.
♦
When you have completed the drainage process,
turn the unit back on and ensure the ‘Water’ and
’Comp’ indicators are no longer flashing. This
signals the process has been carried out correctly
and the unit has been drained.
Note! To stop the buzzing indicator sound, press any
button on the unit’s remote control.
Note! Always wait at least 3 minutes after switching
off the unit before turning it back on. This will help
prolong the life of the compressor.
Draining Without the Tank
♦
You can also drain the unit without needing to
empty the water tank. To do so, simply remove
the drain plug and plug cap, insert the drain tube
into the water outlet, and connect the other end of
this tube into a drain, as shown in the illustrations
below.
Note! The drain must be at or below the outlet level.
Note! Please note that when using this method of
drainage, the ‘Water’ indicator on the unit’s control
panel will not flash.
Drain Tube
Extending the Drainage Tube
♦
The drainage tube can also be extended using
a tube of a similar diameter (18mm) and an
appropriate connector, as shown in the illustration
below.
Extension Tube Original Tube
Self-Diagnosis
♦
This unit is equipped with a self-diagnose feature,
which warns you of any errors or malfunctions
it finds in the course of its normal operation.
Any errors the unit finds when running its self-
diagnose will be represented by the words ‘E1’ or
‘E2’ appearing on the display panel.
♦
Should any malfunction occur, please seek out
a specialised technician or contact our customer
support team.