Black & Decker BHFE520J, Руководство пользователя

Страница: 9 / 20

9
ENGLISH
4. Charging port
5. Vacuum inlet
6. Extension tube
7. Accessory release latch
8. Dust canister
9. Floor head
10. 2 in 1 Accesssory tool
10a. Accesssory storage clip
11. Jack plug charger
12. LED worklight
Assembly (Fig. A, BF)

Align the top of the extension tube (6) with the vacuum
inlet (5) as shown in Fig. A.

Push the extension tube (6) onto the vacuum inlet (5) so it
locks into position.

Align the bottom of the extension tube (6) with the fl oor
head (9) as shown in Fig. B.

Push the bottom of the extension tube (6) onto the fl oor
head (9) so it locks into position.

To remove an accessory, press the accessory release
latch (7) located on the vacuum or extension tube and
gently pull the connected accessory off.
Warning! When not in use position the unit with the rear of
the vacuum facing a wall so that any inadvertent fall of the unit
would contact a wall and not people or pets.
Charging the battery (Fig. C)
Warning! Use only with the supplied charger. From new, the
rechargeable cells of the product need a minimum charge
time of 5 hours to ensure full power.
Note: We recommend that you charge the unit in the storage
position as shown in figure T.

The unit must be turned Off in order to charge.

Fig. C - Plug the jack plug (13) of the jack plug charger
(11) into the charging port (4) of the vacuum.

Plug the charger into a standard electrical outlet.

While charging, the charger may get warm, this is
perfectly normal and safe. It is safe to leave the appliance
connected to the charger inde
fi nitely. The charger
automatically reduces power consumption when charging
is complete.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C. Follow all charging instructions
and do not charge the appliance outside of the temperature
range specified in the instructions. Charging improperly or at
temperatures outside of the specified range may damage the
battery and increase risk of fire.
State of charge indicator
This appliance include a state of charge indicator (3) which
consists of three green and one red LED lights that indicate
the level of charge remaining in the battery. This feature is
only activated when the vacuum is powered on. The state
of charge indicator is an indication of approximate levels of
charge remaining in the battery pack.
The LED battery indicator displays the remaining charge and
warns you when the battery is low. The
fi nal red LED will fl ash
continuously when there is only very little runtime remaining.
Note:
The state of charge indicator is only an indication of the
charge left on the battery. It does not indicate tool functionality
and is subject to variation based on product components,
temperature and end-user application.
Use
This vacuum cleaner can be used in one of four ways.

With the extension tube (6) and the fl oor head (9) as
shown in fi gure D.

With the fl oor brush (9) and the vacuum as shown in fi gure
E.

With the extension tube (6) and the 2 in 1 Accesssory tool
(10) as shown in
fi gure F.

With the 2 in 1 Accesssory tool (10) and the vacuum as
shown in
fi gure G.
Note: The 2 in 1 Accesssory tool (10) can be used as either
a crevice tool or a brush tool, as illustrated in fi gure F.
Switching ON and OFF (Fig. H)

To switch ON, slide the on/off power switch (1) forward to
the “ I “ position.

For increased power, slide the On/Off switch ( 1 ) forward
to the “ II “ position.
Note:
The fl oor head (9) will power on when it is attached
to the vacuum or extension tube. The LED worklight (12) will
illuminate whenever the unit is switched ON.
Note:
The state of charge indicator LEDs (3) will illuminate
while the vacuum is ON as shown in fi gure I.

To switch OFF, slide the on/off power switch (1) to the “O“
position.

Return the product to the charger immediately after use
so that it will be ready and fully charged for the next use.
Ensure that the product is fully engaged with the charger
plug.
Cleaning and emptying the vacuum
Warning! Projectile/Respiratory Hazard: Never use the vac
without its filter.
Warning! The filter is re-usable, do not confuse it with
a disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the filter
every 6–9 months depending on frequency of use. There are
two methods of cleaning the canister, a quick empty method
and a thorough clean method.