6
ENGLISH
(Original instructions)
Children should not have access to
stored machines.
When the machine is stored or
transported in a vehicle it should be
placed in the boot or restrained to
prevent movement following sudden
changes in speed or direction.
Inspection and repairs
Before use, check the machine for
damaged or defective parts. Check
for breakage of parts and any other
conditions that may affect its operation.
Do not use the machine if any part is
damaged or defective.
Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
Never attempt to remove or replace
any parts other than those specified in
this manual.
Additional safety instructions for
grass trimmers
Warning!
Cutting elements continue to
rotate after the motor is switched off
.
Be familiar with the controls and the
proper use of the machine.
Before use, check the power supply
cord and extension cord for signs of
damage, ageing and wear.
If a cord becomes damaged during
use, disconnect the cord from the
mains supply immediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Do not use the machine if the cords
are damaged or worn.
Before using the machine and after
any impact, check for signs of wear or
damage and repair as necessary.
Always ensure that the ventilation slots
are kept clear of debris.
Wear stout shoes or boots to protect
your feet.
Wear long trousers to protect your legs.
Before using the machine, check that
your cutting path is free from sticks,
stones, wire and any other obstacles.
Only use the machine in the upright
position, with the cutting line near the
ground. Never switch the machine on
in any other position.
Do not overreach and to keep your balance
at all times. Always be sure of your footing
on slopes and walk, never run.
Do not work on steep slopes. Work across
the face of slopes, not up and down.
Move slowly when using the machine.
Be aware that freshly cut grass is
damp and slippery.
Never cross gravel paths or roads
while the machine is running.
Do not to touch moving hazardous
parts before the machine is
disconnected from the mains and the
moving hazardous parts have come to
a complete stop.
Never touch the cutting line while the
machine is running.
Do not put the machine down until the
cutting line has come to a complete
standstill.
Use only the appropriate type of
cutting line. Never use metal cutting
line or fishing line.
Содержание BESTA525
