4
SYMBOlS
• The label on your tool may include the following symbols. The symbols and their definitions
are as follows:
V ..................volts A ...................amperes
Hz ................hertz W ..................watts
min ..............minutes
or AC .......alternating current
or DC ..direct current
no .................no load speed
................Class I Construction
.................earthing terminal
(grounded)
................safety alert symbol
................Class II Construction
.../min or rpm...revolutions or
(double insulated)
reciprocation per minute
............
Read instruction manual before use
.................
Use proper respiratory protection
................
Use proper eye protection
.................
Use proper hearing protection
SAVE ThESE INSTRUCTIONS
FUNCTIONAl DESCRIPTION - FIGURE A
1. Garden shear hedge trimmer attachment 2. Grass shear blade
3. Hedge trimmer blade
4. Blade release button
5. Blade cover
6. Active lock-off button
ASSEMBlY
DANGER:
kEEP hANDS AWAY FROM BlADE.
Contact with blade will
result in serious personal injury.
WARNING:
To reduce the risk of injury, turn off and remove battery from tool
before making any adjustments or removing or installing attachments or accessories.
REMOVING ThE BlADE - FIGURE B
• To remove the blade cover (5) push and hold the blade release button (4) in the direction of
the arrow (fig. B)
• Slide the blade cover (5) backwards and lift it off (fig. B). remove blade.
FITTING ThE BlADE - FIGURE C, D
• To install the blade cover, position blade and garden shear hedge trimmer attachment as
shown in figure C.
• Fit blade onto the pins on the garden shear hedge trimmer attachment as shown in figure C1.
NOTE:
The retaining magnet (7) will keep blade secured to garden shear hedge trimmer
attachment.
• Place thumb on blade away from cutting area as shown in figure D. Align blade cover tabs
as shown in figure D1.
• Slide blade cover forward until and audible click is heard and the cover is locked into position.
NOTe: Alignment of blade with drive pin and alignment of the back of the blade and the
retaining magnet (7) is required when re-fitting the blade cover.
OPERATING INSTRUCTIONS
DANGER:
kEEP hANDS AWAY FROM BlADE.
Contact with blade will
result in serious personal injury.
WARNING:
Shock hazard.
Under no circumstances should this product be
used near water.
