31
ENGLISH
TROUBLESHOOTING GUIDE
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Unit will not start.
Battery pack not installed properly
Battery pack not charged.
Internal componets too hot.
Brushes worn out.
Check battery pack installation
Check battery pack charging requirements.
Allow tool to cool down.
Have brushes replaced by an authorized
BL
AC
K+DECKER service center.
Battery pack will not charge.
Battery pack not inserted into charger.
Charger not plugged in.
Surrounding air temperature too hot or too cold.
Insert battery pack into charger until LED
illuminates.
Plug charger into a working outlet. Refer to
"Important charging notes" for more details.
Move charger and battery pack to a surrounding
air temperature of above 40 degrees F (4,5°C) or
below 105 degrees F (+40,5°C).
Unit shuts off abruptly.
Battery pack has reached its maximum thermal
limit.
Out of charge. (To maximize the life of the
battery pack it is designed to shut off abruptly
when the charge is depleted.)
Allow battery pack to cool down.
Place on charger and allow to charge.
Dust is not being collected.
Sandpaper holes do not align.
Dust bag is full.
Use sandpaper with the appropriate hole
configuration.
Separate dust bag and gently shake or tap to
empty.
SERVICE INFORMATION
BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER Service
Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. For more
information about our authorized service centers and if you need technical advice, repair, or genuine factory replacement
parts, contact the BLACK+DECKER location nearest you, or visit us at
www.blackanddecker-la.com
CHARGER
TYPE
AR
B3
B2
BR
Input voltage
V
100 - 240
Frequency
Hz
50/60
Output
voltage
V
8 - 20
Current
mA
400
Charge time
hr
3 - 4
BATTERY
LD120BAT
Voltage
20 V
MAX*
Capacity
Ah
1.5
Battery type
Lithium Ion
* Maximum initial battery pack voltage (Measured
without a workload) is 20 volts. Measured under a
workload, nominal voltage is 18V.
** 10 screwd 1 dr 1 hammer drilling
