Black & Decker BAPUV250, Руководство пользователя

Страница: 14 / 20

Page 14
SET UP & USE
FILTER INSTALLATION
Your air purifier comes with an 8 stage (2-Pre-Filters, 2-True HEPA H13 Filters,
2-Activated Carbon Filters, 2-Photocatalyst Filters) Filtration system.
To access the filters:
1. Remove the front panel by pulling the top outwards with both hands.
2. If using for the first time, carefully remove each filter and their packaging, and
remove tape from UV lamp from unit.
To reinsert filters:
1. Replace with new filters in sequence as listed below, and snap into place.
2. Reattach the front panel by aligning the bottom edge first and gently pushing
the top into the original position. Ensure tab is facing forward when re-inserting
back into the unit.
The FILTER REPLACEMENT indicator light will be slowly flashing red after 2160
hours of use. The HEPA and CARBON filters should be replaced at the same time.
You may need to replace them sooner if you are using the air purifier in an
environment with poor air quality. If you notice that the filters do not appear visibly
clean, or air purification seems to have decreased, the filters should be replaced.
WARNING:
Do not run the unit without the filters in place.
the front panel
pre-filter
uv tube
uv tube
pre-filter
the front panel
True HEPA filter
Photo-catalyst
filter
activated carbon
filter
activated carbon
filter
True HEPA filter
photo-catalyst
filter