Black & Decker BAPUV250, Руководство пользователя

Страница: 10 / 20

Page 10
SET UP & USE
Remote Control:
Air purifier can be operated using the remote control.
1. To turn the unit on, press the ON/OFF Button.
2. To operate fan speed low, medium or high on 1 (LOW), 2 (MEDIUM), 3 (HIGH) or
4 (MAX) press the FAN SPEED button. Continue to press until the appropriate
speed is highlighted on the unit.
3. Press SILENT mode if you would like the fan speed on lowest option.
4. Press AUTO
A
if you would like the fan speed to automatically set according to
the air quality in the room.
5. Press TIMER if you would like to choose 1, 4 or 8 hour option.
6. Press UV Lamp if you would like the UV Sensor activated.
7. Press RESET after you replace the filters. Hold for 5 seconds.
Filter Replacement Light
WARNING:
Unplug unit before replacing filters.
After 1,600 hours of use, the REPLACE FILTER indicator light will illuminate red
and flash. Replace the 2 HEPA filters and 2 Activated Carbon filters. After the filters
have been replaced, touch the RESET button for 5 seconds to reset. The REPLACE
FILTER indicator light will turn off and the other control panel lights will illuminate.
NOTE: Refer to CLEANING AND MAINTENANCE section of this manual for
information about how to access and install the filter.
To shut OFF the unit at any time, touch POWER and it will illuminate red with
other indicator lights off. Unplug the unit.
WARNING: Do not run the unit without the filters in place.
Air Quality Indicator
Air quality Indicator (PM2.5) will adjust based on the air quality in the environment.
Blue
0-50 Excellent
Green 50-100 Good
Purple 100-150 Normal
Red
150- Poor