BKI Countertop Rotisserie Oven FS, Инструкция по установке и эксплуатации

Страница: 11 / 16

Countertop Rotisserie Oven Operation
9
If a cycle is changed during a timed cook or hold cycle and the time is set for a value that is less than the elapsed
time for the current cycle, the cycle will be completed when the review mode is exited.
If the cycle in progress goes into audible alert while in review mode, the controller will exit review mode and all
changes will be canceled.
Programming
Setting a Program
1. Press the ITEM SELECT button to select the desired program (indicated by the illuminated LED).
2. Press and hold a function ( COOK TEMP , COOK TIME , HOLD TEMP , OR HOLD TIME ) button. The
current setting will be displayed.
3. Press the UP or DOWN button as needed to display the required setting.
•
The hold mode may be disabled on any program individually. The timed cook cycle may also be
disabled, and the controller will operate as a holding timer. This is done by setting the cook or hold
time to “
OFF
”.
•
The controller may also operate with the cook and/or hold temperature set to “
OFF
”. When both the
cook and hold temperature are set to “
OFF
”, the controller will not regulate the oven temperature.
This feature is intended for demonstration or display purposes.
Reviewing a Program
1. Press the REVIEW button. The display will be blank and a program LED will be flashing.
2. Press the ITEM SELECT button to display the flashing LED for the desired program.
3. Press and hold the desired function button. The current setting will be displayed.
4. To change the setting, press the UP or DOWN button while holding the function button.
•
If a button is not pressed within five (5) seconds, the controller will exit review mode and continue the
cycle previously in progress.
•
The cycle in progress will continue to count up or down accordingly while in the review mode.
•
If a cycle is changed during a timed cook and/or hold cycle and the time is set for a value that is less
than the elapsed time for the current cycle, the current cycle will be completed when the review mode
is exited.
•
If the cycle in progress goes into audible alert while in review mode, the controller will exit review
mode and all changes will be canceled.
Cooking
1. Place the POWER switch, OVEN LIGHTS switch, and ROTOR CONTROL switch located on the front
panel in the “ON” position. The controller will automatically load the settings from the last program
selected and begin regulating to the cook or hold temperature. Typically, the oven temperature is too cool
upon power-up. If the oven temperature is below the programmed temperature, the display will alternately
flash “
too
”, “
CooL
” until the oven temperature reaches the programmed temperature.