STEP #10 -
Lower the cylinder and the first 8' section of piping into the
well. Using the slotted aluminum paddle you received with your pump,
slide it under the PVC bell end of the pipe and rest the paddle on top of
the well casing. This will hold the pipe in place while you assemble the
rod and pipe. Continue to connect the 3/8" rod sections and PVC pipe
until you have lowered all of the pipe into the well.
STEP #11 –
Attach the rod retrieval tool to the last section of rod and pull all the way up. Attach vice
grips to hold the rod up from the pipe. Remove the 3/8" Allen head shoulder bolt at the top of the
handle connection to the lift rod (See Detail "A").
STEP #12 -
Screw the 3/8" rod that is protruding from the bottom of the well head into the last rod
sticking out of the PVC pipe. Tighten these rods together using plier or vice grips and a 9/16”
wrench. Thread the jam nut up against the lift rod and tighten. Screw the Well Head into the PVC bell
end of the pipe. (This step is performed more easily with two people.)
STEP #13 -
Tie the end of the safety rope to the 1/4" eye bolt on the underside of the well adaptor
(See Detail "A"). Set the well adaptor and pump head onto the casing, squarely and straight; then
evenly tighten the (4) stainless steel nuts on top of the well adaptor. Tighten the (4) allen head set
screws on the well adaptor to secure it to the casing. Check to make sure the pump head is square and
straight on the well casing; making sure all the bolts are tight. Place the (4) rubber boots on the allen
head set screws of the well adaptor. Reconnect the pump handle to the lift rod with the 3/8" Allen
head shoulder bolt. Ensure the set screw in the eyelet at the top of the handle is facing back towards
the handle.
Do not over tighten the shoulder bolt as this will cause the pump handle to pump
hard.
STEP #14 -
Pump the handle on your Bison Deep Well Hand Pump and enjoy a cold glass of water
directly from your well.
If you are currently treating the water in your home, remember that the water you pump directly
from your well is untreated water. Bison Pumps recommends that you have your water tested to be
sure that it is good quality potable drinking water.
Содержание BPN-330C
Страница 6: ......
