Rev. 1.00
- 34 -
SLP-DL410B/DL413B
1) Turn on the printer power.
2) The printer mode is set to Printer Setting Mode when the Pause button is pressed
for two seconds while in Print Standby Mode.
3) Both LEDs will change to orange color and the printer will be set to Stand-alone
Configuration Mode.
4) When the printer enters into this mode, the status of LED 1 and LED 2 are
changed sequentially.
5) SSP mode setting will be enabled by feed button. Refer to below table.
(LED1 : Red Lit, LED2 : Green blinking, Sequence number 7)
6-3-1 List of supported functions
Sequence
number
LED 1
LED 2
Printer operation
Color
Status
Color
Status
1
Green
On
Green
Blink four times Print Configuration Info.
2
Orange Blink four times Print File List
3
Red
Blink four times Factory Reset
4
Orange
On
Green
Blink four times Gap Sensor Auto Calibration
5
Orange Blink four times B/M Sensor Auto Calibration
6
Red
Blink four times Data Dump Mode
7
Red
On
Green
Blink four times BT SSP MODE(PinCode/SSP mode)
8
Orange Blink four times Line Mode
9
Red
Blink four times Download Items Delete
6-4. SSP Mode Check
1) Implement the “Print configuration Info.” by Stand-alone Configuration Mode.
2) SSP mode is enabled if “BT SSP Mode” printed “SSP MODE” at the paper.
3) SSP mode is disabled if “BT SSP Mode” printed “PINCODE MODE” at the paper.
