Rev. 1.00
- 19 -
SLP-DL410B/DL413B
4. Self-Test
The self-test checks whether the printer has any problems.
(Users cannot perform this procedure if using the printer’s label peel-off option.)
- Firmware version, printer configuration information, printing quality checking pattern,
and peripheral configuration information, etc.
If there is no problem according to self-test result, please check other device(s) or software(s).
This function is operated independently with other device(s) or software(s).
If the printer does not function properly, contact an authorized dealer.
The self-test checks the following;
1) Make sure that the paper roll has been installed properly.
2) Turn on the power while holding down the FEED button. The self-test begins.
(It takes about 5 seconds before starting self-test)
3) The self-test prints the current printer configuration information.
4) After the self-test results are printed out, a printer enters into Print Standby Mode.
