c) Wires on the plug of the convection fan may have a bad connection, or the connection to the capacitor
may be bad.
1)
Contact your Bixby Dealer
Feed System:
Feed system and Hopper:
A.
Feeder Wheel Cover
:
a) The Feeder Wheel cover protects the Feeder Wheel from the weight of the corn in the hopper and
should be used at all times.
b) When the feeder wheel access plate is installed, the plate prevents smoke from entering the room,
should a flue block occur or stove shut down occur.
Feeder Wheel Assembly
:
A.
Feeder Wheel does not move or run
:
a) Open Hopper lid, remove Feeder Wheel cover, clear jam and restart Stove.
b) Check Feeder Wheel guard- Is it installed correctly and properly?
c) Check for continuity at the snap disk plug (there should be continuity under normal conditions when
snap disc is cool).
1) If there is a question, contact your Bixby Dealer
Touch pad operation and indicating Lights:
A. Four switches
a) ON:
Starts the stove. Also used to reset the stove.
b) OFF:
Shuts the stove down.
c) UP:
Used to increase the setting of the heat level.
d) DOWN:
Used to decrease the setting of the heat level.
B. Eight
LED’s
Indicates the heat level setting.
DOES NOT indicate the heat level in which the stove is currently running at (if the stove was
recently turned up it may not be to the indicated level yet or if the stove is using a built in program
with preset levels (start-up, shut down or ash dump).
A display with blinking LED’s indicates trouble codes which can be used to diagnosis problems (see your
owner’s manual).
Remember, if all else fails: READ THE MANUAL
If the problem with the stove has not been resolved with the
help of the above -
YOUR FIRST CONTACT SHOULD BE
MADE WITH
YOUR BIXBY DEALER!
