3
ã
Bittner-Audio
BITTNER Installation & Operations Manual
To reduce the risk of fire or electrical shock, do not expose this appliance to rain or moisture. Do not use this
unit in damp areas or near water.
The amplifier must be adapted slowly to extreme temperature changes. These extreme changes can cause
moisture development inside the amplifier that can cause failure and /or electrical shock.
Though the amplifiers from BITTNER are quite simple to operate and are covered by a solid chassis,
improper use can be dangerous. Some of the amplifiers can put out very high voltages and a sizable current
at frequencies up to 30 kHz.
NEVER isolate the ground of the AC power cord (the non-fused earthed protective conductor) to eliminate
hum-problems. See chapter ‘Grounding’.
Always use safe operating techniques! Incompetent and improper servicing can void the warranty.
With the in-build DSP processor extended functionality is available:
-
Level Control
-
Input routing of the input channels to the two amplifier channels
-
10-Band Equalizer
-
Dynamics (Limiter/Compressor/Gate)
-
Delay
-
Cross-Over
-
Up to 100 presets
I
NSTALLATION
Upon unpacking, please inspect the amplifier. If you find any damage, notify your supplier immediately. Be
sure to save the carton and all packing materials in case you have to send the product to the supplier.
Please use only the original factory packing. If the shipment carton is unavailable, contact BITTNER-Audio to
obtain a replacement.
The amplifiers will mount in standard 19-inch racks having sufficient depth. For the installation 4 standard
bolts should be used. For proper mechanical stability the use of supporting rack slides on the bottom of the
amplifier is necessary.
Front Panel
Rear Panel
(image can differ slightly from the actual version)
