Page 72 of 191
800581-2.11 NeurOne System User Manual.doc
Accept mute triggers
– If set on, the monitor shows incoming mute triggers.
Accept 8-bit triggers
– If set on, trigger selection control appears. The control has the
list of checkboxes for each 8-bit combination 1
– 255. Check the desired combination
to be accepted during the measurement. There are also buttons All and None for
selecting/deselecting all.
Show grid
– If set on, grid of the drawing area is shown.
Background color
– Opens the control for background color selection of
measurement raw monitor.
5.3.6.5 Response Monitor
This page defines the response monitor(s) (EP monitoring) to be used in the Protocol.
There can be several response monitor definitions on this page.
The Response page contains the following definition fields:
Name
– Name of the Response monitor.
Trigger event Selection
Main unit
– Definition which Main unit(s) are active inputting/outputting triggers.
Port A
– Accepted response trigger type selection for port A.
Port B
– Accepted response trigger type selection for port B.
Accept 8-bit triggers
– If set defined 8-bit trigger combination are accepted. Accepted
trigger combination are selected on the control on the right of the tab (refer Raw signal
monitor).
Port SyncBox EXT
– SyncBox Ext trigger type selection.
