Bitspower BP-DIO240-TBBK, Руководство по установке

Страница: 8 / 15

P 7
V3
DRGB LED
Intel socket 2011 CPU water block installation
Intel socket 775/115x CPU water block installation
Apply block over Intel CPU
Install the CPU
3
Connect the RGB light effect wire
4
Before use, please make sure that the motherboard
you choose has DRGB (Digital RGB) lighting effect and
its appropriate connector, usually 3PIN. Or you can
also
use Bitspower's lighting controller -
BPTA-DRGBMFC.
SCM3F
SPRING
1 MM WASHER
Screw for Intel 2011 socket
Use an appropriate amount
of thermal paste.
Thumb screw
SCM3F6 screw
1mm WASHER
1mm WASHER
SPRING
Use an appropriate
amount of thermal
paste.
M3x32mm SCREW
SILICONE PAD
BACKPLANE PASTE PAD
METAL BACKPLANE
IN
OUT
When using the hub board for DRGB lighting, please cut off the excess PIN pin
as indicated on the picture.
Note: The hub board main purpose is to group all RGB connectors together
for easy cable management. This hub has no lighting effect control function.
BPTA-HUB-RGB
The thumb screw cannot
be locked too tightly, the
spring is slightly pressed
and the gap is kept as
shown below. The thumb
screw cannot be rotated
to the end. When the
spring screws too tight,
the SCM3F6 screw will be
driven and will be taken
away from the mother-
board, which will cause
the water block and CPU
not to be closed well.
8
G