10
DS901407-001
DS901407-001
11
CODE
: user
code.
Set a number from 0 to 127 according to the following rules:
No two apartments in the system can have the same user code.
Indoor stations in parallel in the same apartment must have the same user code.
User codes be consecutive in the same column must.
Use the CODE dip switches from 2 to 8 (2= most signifi cant bit - 8= least signifi cant bit) to set the required
code. Dip switch 1 must be OFF.
INT
:
apartment station code.
Set a number from 0 to 3 according to the following rules:
The indoor station code must be 0 if there is only one station in the apartment.
Up to 4 apartment stations can be connected in parallel using the same user code and different indoor
station codes.
The indoor station code is used to identify the single stations of the same user. This means that intercom calls
can be address to the single user in the same apartment. All the users indoor stations will ring at the same
time in the event of intercom calls to different apartments, door unit calls and fl oor calls. Extension 0 rings
immediately when a call is received. Extensions 1, 2 and 3 will ring in sequence after each other.
LINE TERMINAL SETTINGS
ON
12345
1
2
ON
Line termination
OFF
ON
A line terminal jumper is fi tted in the door phone. Activate the terminal for devices wired at the end of a line
from which another section does not start from the device terminals (end of line):
Termination
ON
Termination
OFF
BUS OUT
BUS IN
BUS 1
BUS 3
BUS 4
BUS 2
Termination
ON
BUS 1
BUS 3
BUS 4
BUS 2
Termination
ON
BUS OUT
BUS IN
•
•
•
•
•
PERFORMANCE
CALL RECEPTION
The user’s apartment station will ring with the programmed tone when a call is received according to the
source:
From main door unit
From secondary door unit
Intercom call
Floor calls
From switchboard
From reception of the call, it is always possible to activate the electric lock of the call station also without
lifting the handset.
Indoor station 0 will ring immediately if there are several stations in the apartment. Extensions 1, 2 and 3 will
ring in sequence after each other.
INTERCOM CALL FORWARDING
After programming the button for the intercom function, pickup the handset and press the button.
The following cases can occur according to the calling indoor station state:
Indoor station free: the calling indoor station will output a confi rmation tone (2 beeps) and the called
indoor station will ring. Communication is established when the called user picks up.
Indoor station busy: the indoor station outputs a warning tone (4 beeps in rapid sequence). Hang up and
try again later.
FUNZIONE CHIAMATA AL PIANO
The door phone is equipped with a pair of terminals (P) for connection of the call to fl oor button. When the
button is pressed, the internal station emits a 3s long ring with a different tune from the door phone call.
Connect this button only to one indoor station if there are several indoor stations in parallel. Extensions 1, 2
and 3 will ring in sequence after each other.
GESTIONE SONERIA SUPPLEMENTARE
The door phone is equipped with a pair of terminals (S-, S+) for connecting a supplementary ringer or a relay.
This ringer is controlled when any call tone is generated.
ADJUSTING CALL VOLUME
When the selector is in the upper position the maximum ringer volume is set; with the selector in middle
position the minumum ringer volume is set and with the selector in the lowest position the ringer is completely
excluded. This last position is signalled by a little red fl ag, that appears at the bottom of the door phone.
•
•
•
•
•
•
•