BITO WS, Инструкция по сборке и эксплуатации

Страница: 6 / 52

ALL
GEMEINE SICHERHEIT
SHINWEISE
6
1
GB
1. Exclusion of liability / Safety instructions
The present instructions of assembly and use must
be made available to every user before a storage
installation goes into operation.
All instructions given in this document must be
followed at all times.
BITO-Lagertechnik disclaims liability for all damages
arising from non-observance of these instructions of
assembly and use.
DGUV 108-
007
Observe the
regulations
issued by your
national/local
Occupational
Accident
Insurance
Institution(s).
Head
protection
General remark Safety shoes
Risk of slipping
and falling
Protective
eyewear
Hand injuries High visibility
vest
Do not climb on
shelving
General remark
Safety gloves Hearing
protection
2. General safety notes
BITO shelving and racking is intended for storing and picking
unit loads such as cartons, bins and containers or individual
items.
This storage installation has been designed for manual
loading and retrieval (servicing with lift trucks is not allowed).
Unit loads, shelf loads and bay loads must not exceed
rated load capacity limits. Make sure that loads are evenly
distributed since structural design has been been calculated
for uniformly distributed loads.
Any other use or any use exceeding that speci fi ed is an
infringement of use for the intended purpose.
Follow the instructions on design & layout, components &
technical equipment, assembly & operation speci fi ed in the
order documents.
Observe your national/local safety regulations for warehouse
equipment and machinery issued by your statutory accident
insurance association(s) as well as the regulations set up by
your occupational health and safety at work acts and relevant
general accident prevention regulations.
The present instructions do not apply for shelving and
racking used outdoors or in harsh environments subject to
wind, snow and other mechanical stress factors. Moreover,
load capacities indicated in the present document are not
valid for earthquake hazard zones (structural design does
not resist seismic forces). Inform BITO in writing if your
installation is to be set up in an earthquake hazard area and
request adaptation of structural design parameters to the
seismic requirements of your region.
Damaged or deformed racking components must
immediately be replaced.
BITO Shelving and racking is not suited for use in
environments with exposure to corrosion, splashing liquids,
decomposition, vibrations, explosions, radiation.
It is not permitted to use loads or load carriers which due
to their nature are subject to oxidation, rust, decomposition
or which might impair proper functioning of any kind of
mechanism.