Bitfury Tardis — Quick Start Guide
4
3.
Connecting to Bitfury Tardis
Miner
Securely insert your Ethernet cable into the network port and the other end into your
DHCP-enabled router.
Then plug the power cord into your miner and then into a power outlet. The green LED on
Orange Pi Zero should turn on. This means that the SD card is detected, and the operating
system is loading. If the green LED does not turn on, please repeat this process.
After the LED light turns on, please wait one minute and then locate your miner on the
network via the administrative interface of your router (MAC addresses of the Bitfury
Tardis Miner begin with 16:BF:01):
You can connect to your miner via web
interface:
http://[Miner IP Address], for example:
http://192.168.1.224
Login: [email protected]
Password: Qw1Qw1Qw1
ATTENTION:
During first run, please perform the following operations:
1.
Change passwords to prevent unauthorized access to your miner;
2.
Initiate internal firmware update for hashboards by navigating to
Miner
→
Service
→
Firmware Update
menu and pressing [YES] button (please wait a few minutes after
pressing [
YES
]).
