Bitfury Tardis — Quick Start Guide
3
2.
Preparing the Bitfury Tardis
Miner for Firmware update
PLEASE NOTE:
During its first run, the Bitfury Tardis Miner will need to update its internal
firmware. To allow firmware update, the special X jumper should be set according to the
image below. Please only perform this operation when your Bitfury Tardis Miner is
switched off.
Location of X jumper inside of a Bitfury Tardis Miner
Internal firmware should be updated during the first run by navigating to
Miner
→
Service
→
Firmware Update
menu and pressing [
YES
] button (please wait a few minutes after
pressing [
YES
].