BITalino (r)evolution
User Manual
15 of 30
2.2. Connecting the BITalino devices with sensors and actuators
2.2.1. BITalino (r)evolution
Board
The BITalino (r)evolution Board comes with sensors and actuators attached to it (see
Figure 10). The sensors EEG, EDA, ECG, and EMG need to be attached to an electrode cable
using the sensor port (marked in red).
Figure 10: BITalino (r)evolution Board with pre-connected sensors and actuators. Sensor ports for connection to
an electrode cable marked in red.
The correct electrode cable (2-/3-lead) can be found in Table 3 and the setup in Figure
11Figure 13.
Table 3: Sensors and electrode cable combinations.
Sensor
2-lead
3-lead
Additional info
ECG
x
EDA
x
EMG
x
EEG
x
