w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
8
to maximize performance and extend
life of your vacuum it is very important
to perform the following maintenance
steps.
empty dirty container
1.
Turn power
off
. Unplug power cord from
electrical outlet.
2
Empty when dirt reaches the “Full” line on
the container.
3.
Slide Lock ‘n Seal lever to
“unlock”
position.
4.
Grasp dirt cup portion handle and pull
straight out to remove from vacuum and
empty.
5.
Place dirt container back in the vacuum
and slide lever to lock position.
note: the dirt container may be
washed in warm water with mild
detergent. Make sure it is completely
dry before replacing.
cleaning the pre-Motor filter
1.
Turn power OFF. Unplug power cord from
electrical outlet.
2.
The pre-motor filter protects motor from
debris and is located in the slide out
tray underneath the dirt container. If filter
becomes dirty, pull out the tray, lift out the
foam filter pad and clean it.
note: the pre-motor filter may be
hand washed in cold water with
mild detergent. Rinse well and dry
thoroughly before replacing.
Replacing the post-Motor filter
1.
Turn power OFF. Unplug power cord from
electrical outlet.
2.
The post-motor filter assists in the filtration
process to return clean air to the room.
It is located behind the door on the side
of the vacuum. When the filter becomes
dirty, open door to remove and replace.
the white, pleated hepa Media
filter is not washable.
3.
2.
2.
Unlock
Dirt Cup Handle
DJ68-00375N(EN)-0.0.indd 8
10. 11. 12 �� 4:23
