filling the solution tank
1.
Remove the solution tank by gently pressing
the quick release tabs on the solution tank and
sliding the tank off of the unit.
2.
Open the tank by unscrewing and removing
the cap. Add water and formula* to the
indicated fill lines on the solution tank.
*notE: your Spot lifter powerbrush includes an
8 oz. trial size formula.
3.
Replace the cap before placing the tank back
on the unit.
pre-treating
To aid in the removal of tough, stubborn stains,
pre-treating the stain may be necessary.
1.
Hold the unit above the area to be cleaned.
Using the manual trigger spray, apply a sufficient
amount of water and solution to the stain.
2.
Wait 3-5 minutes before cleaning.
cleaning
1.
Plug in the unit.
2.
Turn the power switch to the “ON”
position. ( i )
3.
While holding the spot lifter Powerbrush
above the area to be cleaned, apply water and
formula by pressing the manual trigger spray,
dispensing fluid to the soiled/stained area.
4.
brushing and suction can be done separately,
based on how you hold and use the unit.
to Use the Dual powerbrushes only:
Tilt the unit forward slightly, placing both
brushes in contact with the carpet. The flat
surface of the brush cartridge should be
parallel to the surface being cleaned.
www.bissell.com
800.237.7691
WaRnInG
Keep spray away from face. Failure to do
so may result in personal injury.
6
Operations
1.
2.
3.
2.
» You may also spray water and formula, with the
manual trigger spray, while the unit is turned on
and you are using the dual PowerBrushes then
suction to clean.
» Check upholstery stuffing before cleaning.
Colored stuffing may bleed through the fabric
when it becomes wet.
» When cleaning a vertical surface (ie: chair back,
auto interior, etc.) begin with a completely empty
collection tank.
» If a significant amount of water and solution
remains in the clean tank, your unit can be stored
with liquid in the clean tank.
» If you do not have the Brush Cartridge in all the way,
the Dual PowerBrushes will not rotate. Firmly push
the cartridge in place, while listening for the “snap”
to assure proper placement.
Tips
