Handsfree cleaning
1.
Place the unit directly over the spot or stain,
making sure the stain is in the center of the
handsfree cleaning area.
2.
Select which cleaning cycle (surface stain or
set-in stain) you would like to begin with.
Your SpotBot will begin spraying, brushing
and suctioning up the spots and stains in
its pre-programmed cycle. Both cycles have
been tested and proven to deliver superior
cleaning results, taking the guesswork out of
cleaning for you.
3.
When the cleaning cycle you have selected
is complete, the SpotBot will beep. The beep
will continue every five seconds until you
depress the stop button.
4.
Pick up the unit and check the area that
was cleaned.
5.
If you have used Oxy GEN2, this chemical
will continue to work for the next six to eight
hours, cleaning your spots and stains all the
way to the backing of the carpet.
O
peration
9
w w w . b i s s e l l . c o m
Tip:
Some difficult stains may
require that you run the
cleaning cycle a second
time.
Tip:
If the unit accidentally tips
or is tilted, the handsfree
cleaning brushes will stop.
