Hose cleaning
1.
Before turning off the SpotBot, suction
up clean water to thoroughly rinse out
the inside of the hose. Then, lift the hose
upwards to drain any remaining water into
the dirty tank.
2.
Disconnect the cleaning tool from the
hose by pushing down on the release button
and pulling straight off (do not twist tools to
remove them).
3.
Once the tool is removed from the hose it
can be cleaned by rinsing under clean
running water. When thoroughly dried, place
back into the storage area.
Storage
1.
Unplug the power cord from the outlet. Wrap
power cord around the cord wrap.
2.
Empty and rinse the dirty/collection tank
after each use, or when dirty water reaches
the indicated maximum fill line. To remove,
lift up the tank latch and pull the dirty/
collection tank out. Dump out the dirty water
and rinse with clean water. Replace the
dirty/collection tank back into the unit for
storage.
3.
After using the SpotBot’s handsfree feature,
wipe the window and brushing area with a
soft cloth.
4.
If you were using your SpotBot manually,
wrap the vacuum flex hose around the unit
and secure the spray trigger into the storage
area on the front of the unit.
5.
Store unit indoors at room temperature
(4° to 43°C).
11
w w w . b i s s e l l . c o m
M
aintenance and care
Tip:
If a significant amount of
water and formula remain
in the clean/solution tank,
your unit can be stored with
liquid in it. however, if you
have added oxy GEN2 into
the clean tank, fresh oxy
GEN2 should be added prior
to the next use to
optimize performance.
Tip:
Periodically clean out the
black valve inside of the
dirty/collection tank.
