2
1
3
Press and hold in tab on the battery tray
and pull outward with the tray to remove
Remove old battery from the tray and
replace with a new battery. (Uses one
CR2025 battery).
Replace the battery
tray in to the remote
Changing the Battery in the Remote Control
NOTE:
Be sure to remove the
insulation sheet before using
your remote. It will be sticking
out of the back of the battery
door.
NOTE:
For additional information, please refer to the SmartClean Robotic Vacuum User Guide.
Cleaning Mode
Key Pressed/
Control Key
Action
AUTO
Set the unit in auto clean mode. This mode will cycle through Spiral, Along
the Wall following, “Z” formation and Random modes.
SPIRAL
Vacuum will work in circles until it encounters an obstacle. Once the unit
encounters an obstacle, it will transition to AUTO mode.
RANDOM
Vacuum will move randomly around the room.
ALONG
THE WALL
Vacuum will clean along walls and edges.
Timer
Key Pressed/
Control Key
Action
MAX
Product continues to clean until the battery becomes low. Then returns to
its docking station.
60
Product cleans for 60 minutes then returns to its docking station.
45
Product cleans for 45 minutes then returns to its docking station.
30
Product cleans for 30 minutes then returns to its docking station.
DOCKING
Sends the vacuum to begin looking for its docking station to recharge.
160-8475 rev 11/15 RevD
Troubleshooting
Remote
control
doesn’t work
Check the remote battery.
Check if insulation sheet is still in the
remote. Remove by pulling the tab.
If not, replace with a new CR2025
battery per the instructions above.
The robot is off
Turn the power switch on the robotic
vacuum to the ON position
