w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
perations
10
Hard floor cleaning
(select models only)
1.
Remove the collection tank (refer to steps
2a and 2b on page 7).
2.
attach the hard floor tool by hooking it
into the front of the removable nozzle and
rotate until it snaps firmly in place.
3.
Replace the collection tank. be sure to
attach the two latches.
4.
fill the solution tank with hot (not boiling)
tap water to the WateR fill line. fill the rest
with bissell 2X hard floor solutions™ to
foRmula fill line.
5.
follow steps 1-8 under "carpet cleaning"
on page 6 and 7 to continue cleaning.
Cleaning after use
1.
unplug the unit.
2.
Rinse collection tank thoroughly.
2a.
Remove Readytools dial by
rotating it halfway between “tools” &
“flooR cleaning.”
2b.
Pop out knob by using the opening on
the back of the tank. Rinse and replace knob
and collection tank.
3.
Remove tank vent & foam filter (located on
top of the collection tank) and rinse.
4.
clean nozzle window by lifting latch and
removing from machine. Rinse under run-
ning water.
5.
When finished replace nozzle and secure
with latch.
NOTE: For best results, it is
recommended that the nozzle is
cleaned after each use.
6.
Remove lint and hair from red gasket in
base of unit. (do not remove gasket)
7.
Replace the collection tank to the base
of the machine and secure with latches.
2.
4.
WARNING:
to reduce the risk of fire and
electric shock- when clean-
ing a hard floor, the bissell
hard floor tool (203-5683)
must be used and it must
only be used with bissell
2X hard floor solutions
cleaning fluid intended for
use with this appliance.
5.
6.
2b.
3.
2a.
2b.
4.
