16
Dirtlifter
®
PowerBrush does not turn.
Possible Causes
Remedies
The Brush Belt or Pump Belt
Turn the machine OFF and unplug from the
may be broken.
outlet. To check if a Brush Belt has broken,
you will need a flat head screwdriver.
Insert the blade end into the lower slot of the
Belt Access door to release the lower snap. If
necessary, insert the blade end into the upper
slot to release the upper snap. Examine for
belt breakage. The Brush Belt should be
visible, looped around the motor shaft.
If it is broken or missing, please refer to
Part Numbers and Descriptions
on
page 17 before calling Customer Service.
Complete installation instructions will
accompany the replacement belt.
Vacuum not picking up solution.
Possible Causes
Remedies
ReadyTools
™
switch may be at the
Set ReadyTools
™
switch to either Tools or
wrong setting for the cleaning job.
PreTreat or Floor Cleaning.
Drain cap may be missing or not
Remove Tank-in-Tank,
™
loosen and
properly installed at back of
re-tighten Drain Cap.
Tank-in-Tank.
™
Tank-in-Tank
™
lid is not
Re-install lid; refer to
The Basics
section.
properly installed.
Tank-in-Tank
™
is not properly seated.
Tank-in-Tank
™
must be firmly seated to
function; remove and reseat Tank-in-Tank.
™
Poor tool position.
Adjust angle; apply more downward pressure.
(Hand held attachments only).
Tank-in-Tank
™
has picked up
Empty Tank-in-Tank,
™
refer to
maximum dirty water.
The Basics
section.
Troubleshooting - continued
