12
BISSELL.com
2
1
Maintaining the Brush Roll & Nozzle
Turn OFF and unplug
the machine from the
grounded outlet.
Remove the nozzle
from the Foot:
scoop and grip the
Accessory Hose
Door. Pull up to
remove the nozzle.
NOTE:
Be sure to clean the Brush Rolls and nozzle before storing your machine.
Follow these steps if your nozzle becomes clogged with hair or debris.
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF
and disconnect plug from electrical outlet before performing maintenance or troubleshooting.
3
4
At this point, the
nozzle and Brush
Roll cover can
be rinsed under
running water.
The Nozzle Clean
Out Tool can be
inserted to unclog
hair or debris.
Next, remove the
Brush Roll cover
to reveal the
Brush Rolls.
Press on the two
release buttons
and lift straight up.
5
6
NOTICE:
To reduce the risk of a leaking condition, do not store machine where freezing may
occur. Damage to internal components may result.
Return the Brush Roll cover by pushing it straight down.
You will hear a “click” from each push button when the
cover is pushed down into place. Line up the nozzle from
the edge near the floor and rotate to snap back into place.
Use the comb to brush out
the debris or hair from the
Brush Rolls.
click
1
2
Cleaning Machine After Use
First, fill the Clean
Water Tank with
warm tap water
and then empty it
all to rinse. Then fill
again with warm
tap water and
return the tank to
the machine. Twist
cap back on tightly.
To flush and rinse machine:
Turn the machine ON and press
the Spray Trigger for 15 seconds
while making back and forth
passes on a section of carpet.
Release the trigger and suck up
the water.
Empty the Clean Water Tank and
let dry before storing. Wipe your
machine’s exterior with a soft cloth.
