Before you clean
1.
If desired
, move furniture to another area if
cleaning an entire room.
2.
Vacuum
area with a dry vacuum cleaner
before cleaning
3.
Plan your cleaning route to leave an exit
path. It is best to begin cleaning the corner
farthest from your exit
Fill the clean/solution tank
1.
Remove the clean/solution from the base of the
machine by pulling up and out from the back.
You can also detent the handle and pull the
tank straight up if you desire.
2.
Unscrew the black cap and red insert. Remove.
3.
Fill the tank up to the FILL LINE with hot
tap water.
4.
Add 3 ounces of formula (Always use
genuine BISSELL formulas to maximize
cleaning and for the safety of your machine).
OR
If using a BISSELL 3X Concentrate
add 1 ounce of formula.
5.
Replace the cap and insert and tighten by
turning clockwise.
6.
Replace the clean/solution tank back into the
machine. Be sure that the cap is seated in
the receiver.
Carpet cleaning
1.
Make sure the ReadyTools Dial is in the
FLOOR CLEANING position.
2.
Plug the PROdry into the proper outlet and
turn the power
ON ( I )
using the switch in the
back.
3.
With your foot, press the gray handle release
lever located on the back of
the unit. Take care to notice the way the
machine floats forward.
4.
While pressing the spray trigger make 1
forward wet pass and another 1 back.
Repeat once and move on to the next
section of carpet or area rug to be cleaned.
Take care not to run over loose objects of
the edges of area rugs.
7
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
2
4'
3'
1
3
4
5
6
7
9
10
11
12
EXIT
START
HERE
O
peration
Tip:
Thorough vacuuming
before carpet cleaning will prevent
early clogging of the lint screen.
ug120-4080_7350_908.indd 7
10/14/08 1:25:58 PM
