www.BISSELL.com
9
WARNING
Do not operate vacuum with damp or wet filters, as well as without filters or the Dirt
Container in place. Allow components to dry before reassembling the Dirt Container.
Maintenance:
Replace the Brush & Belt
1
3
2
Unplug vacuum, turn over and
unscrew 7 Philips head screws
to remove bottom cover
Pull roller straight
out, threading
through belt
Replace roller and/or belt.
To reassemble roller, thread
through belt and line up End
Cap, then place bottom cover
back on and replace 7 screws.
End Cap
Belt
Maintenance:
Maintain the TurboBrush®/
TurboEraser® Tool
1
3
2
If paddle wheel gets dislodged,
align two clips on each side and
pop into place
Twist gray collar
counter-clockwise, until
slot appears, and then
separate faceplate
Carefully remove brush,
replace belt and brush,
if needed
Faceplate will not
close properly if all
parts are not aligned
correctly
*images may vary
TurboBrush
Align
Slot
Paddle Wheel
Roller
Belt
Paddle Wheel End
Clip
NOTE:
If an object becomes lodged in foot and brush shuts off, turn vacuum
off and unplug from electrical outlet. Remove obstruction and brush will
automatically reset when vacuum is plugged and turned back on.
