www.BISSELL.com
6
Using Your Vacuum
Press the recline pedal to lean your vacuum
back for cleaning. To get even lower, press
the pedal a second time. When you’re
finished, lean it all the way back up to lock
it into the upright position.
NOTE:
Some frieze and berber carpets have long delicate fibers or threads that
may be damaged by rotating brush. Repeated strokes in the same area may
enhance this condition.
WARNING
Before using your vacuum, make sure that the Dirt Tank is in
locked position and that all filters, both pre and post-filters, are in place.
DO NOT operate your vacuum without these filters.
WARNING
The rotating floor brush continues to rotate while tools are in
use. To reduce the risk of injury from moving parts, always move the vacuum with the Carry
Handle at the front of the unit. To prevent carpet damage, do not lean on the vacuum or
let the powerfoot tilt forward. Always place the vacuum on the floor with the handle in the
upright position when using tools. Never place your fingers under the vacuum when it is
running. Never place the powerfoot on furniture or uneven surfaces. Do not place vacuum
close enough to objects to pull them into rotating brush.
Using Automatic Cord Rewind
When you finish using your vacuum,
unplug it from the outlet. Hold onto
the plug and press the Automatic Cord
Rewind Button until it’s fully retracted.
If the cord doesn’t fully retract on the
first try, pull a little bit of cord out and
press the rewind button again.
To plug your vacuum in, gently pull the
cord out of the automatic cord rewind
and stop at the yellow mark on the
cord. Do not pull past the red mark.
Once you have the desired amount of
cord, plug it into the outlet.
Press the red power switch with
your foot to turn ON the unit. Press it
again to turn your vacuum OFF when
you’ve finished cleaning.
NOTICE
The floor brush will continue to rotate while you use your vacuum for above floor cleaning.
To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward.
1
2
1
2
