w w w. b i s s e l l . c o m
O
perations
6
transporting your vacuum
use the handle on the front to carry
the vacuum or place the vacuum in the
upright position and tip back to roll on
the rear wheels.
Releasing the power cord
the upper and lower cord wraps rotate
to allow for quick and easy removal of
the power cord.
fingertip power switch
the power button is located at the top
of the vacuum handle.
to turn vacuum on, press button once.
to turn vacuum off, press button again.
note: the rotating brush will not turn
on unless the vacuum is in the reclined
position and the brush switch is on.
handle positions
use your foot to pull the handle release
pedal back to recline the vacuum cleaner.
height adjustment
there are seven height settings available for
various floor surfaces. turn the dial on the
foot of the vacuum to the desired setting.
lowest setting – for low pile carpet or
bare floors. to pick up debris it may be
necessary to move up one setting.
Medium settings – for medium pile carpet.
high setting – for high pile and most
shag/frieze carpet.
note: for optimal carpet cleaning
performance, adjust to the lowest
practical setting. if your vacuum is
difficult to push, adjust to the next
higher setting.
if the dial is difficult to turn, tilt the
vacuum back slightly to take the weight
off the foot while turning.
attention
:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area may aggravate this
condition. Consider setting
your VACUUM on a higher
than normal setting for this type
of carpet.
