w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
10
Cleaning the pre-motor filter
The pre-motor filter protects the motor
from debris. It is the small, round filter
located underneath the dirt cup, right
above the motor.
1.
Turn off vacuum and unplug it from
electrical outlet.
2.
Remove dirt cup by sliding the dirt cup
release lever to the right. Then pull dirt
cup out.
3.
Lift up lower cup to access the pre-motor
filter.
4.
Remove the small round pre-motor filter
located on the base of the vacuum.
5.
Remove any dust or debris from the
filter. Rinse well under warm water, then
air dry thoroughly before replacing.
Note: always make sure all filters
are in place and thoroughly dry
before using this vacuum.
6.
Replace dirt cup and slide the dirt cup
release lever to lock into place.
Cleaning the upper tank
1.
Turn off vacuum and unplug it from
electrical outlet.
2.
Remove dirt cup by sliding the dirt cup
release lever to the right. Then pull dirt
cup out.
3.
Twist the primary separator to unlock it
and pull it down. Brush off any dirt and
rinse off screen with warm water. Air
dry completely before replacing.
4.
Check hose inlet for any clogging.
5.
Reassemble the primary separator by
centering the front symbol and twisting
toward lock position, as shown.
6.
Replace dirt cup and slide lever to lock
position.
WarNINg:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
2.
3.
4.
6.
6.
Lock Position
5.
Pre-Motor
Filter
2.
3.
