Power
Mode
10s
1.
Press the power button
ON. Press the mode button to
switch between Hard Floor and
Area Rug Modes.
Area Rug Mode dispenses
double the solution as Hard
Floor Mode. Before cleaning
rugs, check the manufacturer’s
tag and test an inconspicuous
spot for colorfastness. Don’t
use on silk or delicate rugs.
2.
Recline the machine to start
the brush roll spinning. Stand
the machine upright to stop
the brush roll spinning.
3.
Before each use, hold the
solution spray trigger for 10
seconds to prime the system
with cleaning solution.
LED lights illuminate when
holding the trigger. Bubbles
will appear in the brush roll
window when the solution is
flowing.
4.
To clean, hold the solution
spray trigger to apply solution
on forward and backward
passes.
5.
To dry floors faster, release
the trigger and make a second
pass without dispensing
solution.
6.
Turn OFF the machine by
pressing the power button ( ).
Sanitizing Hard Floors
Please read “DIRECTIONS FOR USE” on Hard Floor Sanitize label. Use on hard nonporous floors only.
5m
1.
Remove visible soil before
cleaning. Hold trigger down to
apply solution on to the floor.
2.
Allow formula to remain wet
on the floor for five minutes.
3.
With the spray trigger
released, make forward and
backward passes to extract
solution.
Cleaning Your Floors
Go to
support.BISSELL.com
for how-to videos and tips for cleaning stuck-on messes,
excessively dirty or muddy floors, and more!
ATTENTION
Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area
rugs. Stalling the brush may result in premature belt failure.
EN
8
BISSELL.com
