1.
w w w . b i s s e l l . c o m
A
ssembly
The only tool you’ll need to assemble
your vacuum cleaner is a Phillips
screwdriver.
Attach handle to vacuum
1.
Locate the handle and cord wrap. Remove
the screw packet taped to the handle.
2.
Stand the vacuum upright and from the
rear of the unit, slide the base of the
handle firmly into the grooves at the top
of the vacuum body.
3.
Ensure that the handle fits firmly to the vacuum
body. If there are any gaps, continue to push
firmly until the handle is secure.
4.
Insert the provided screw into the existing
hole, attaching the handle to the body of the
vacuum. Tighten securely with a screwdriver.
Attach vacuum hose and tools
1.
Attach the Twist ‘n Snap™ Hose by lining up
the tabs on the base with the corresponding
notches on the back of the vacuum as shown.
2.
Turn the Twist ‘n Snap Hose to the right
to lock the hose into place.
3.
Grasping the Quick Reach Handle, slide the
end of the Hose Wand onto the Hose Wand
Base. Snap the Hose into the Hose Clip.
NOTE: The vacuum will not operate
effectively unless the hose wand is
firmly attached.
4.
Slide the extension wand and crevice tool
into the storage clip on back of vacuum.
5.
Slide the dusting brush/upholstery tool
into the storage clip on back of vacuum.
6.
Store the TurboBrush Pet tool on the front
of the handle by lining up the TurboBrush
Pet tool base with the base of the holder
then push back to snap into place.
5
CAUTION:
Before using your vacuum, make
sure that the dirt container is in the
locked position and that all filters
(pre-motor and post-motor) are in
place. Do not operate your vacuum
without these filters.
NOTICE:
For above floor cleaning, the floor brush
will continue to rotate, but is raised
above floor. To prevent carpet damage,
do not lean on the vacuum or let the
powerfoot tilt forward.
Hose
Wand
2.
4.
Twist 'n
Snap Hose
6.
3.
