w w w . b i s s e l l . c o m
M
aintenance and care
12
3.
Remove the brush from the belt and
clean debris.
4.
Replace the brush inside the belt and
place ends into slots on sides as shown.
5.
Reposition top cover making sure to line
up inside tab at the front with the open-
ing on the cover. Twist collar until open-
ing is at the bottom to lock into place.
Clearing clogs
Low suction or poor pickup may be
due to a clog in the vacuum cleaner.
If you notice a change in the sound of
the motor, check for clogs.
1.
Unplug the vacuum from electrical outlet.
2.
Empty dirt container.
3.
Check upper tank for build up or clogs.
4.
If you notice a clog in the upper tank,
remove the inner cyclone (see section
"Cleaning the upper tank" below).
5.
Grasp the hose wand and separate it
from the hose wand base. Check for a
clog in the base, the wand or in the hose.
6.
Remove the Twist ‘n Snap hose from the
vacuum by turning to the
left
. Straighten
the hose and unclog with a long, narrow
object such as a broom handle.
7.
If the clog persists, follow the instructions for
"Checking the rotating floor brush and drive
belt" on page 10 and inspect the air pas-
sageway for obstructions.
Cleaning the upper tank
1.
Grasp the inner cyclone and twist to the
left until the locking tabs stop the rotation.
Pull down from the upper tank to remove it.
2.
Wipe out the inside of the upper tank and
the inner cyclone with a damp cloth moist-
ened with water or a mild cleaning solution.
3.
If you desire to thoroughly clean the fil-
tration disk located in the upper portion
of the inner cyclone, hold the bottom of
the cyclone and turn filtration disk to the
right and pull up to remove.
4.
5.
Maintaining TurboBrush
™
Pet tool continued
1.
3.
5.
2.
