6
BISSELL.com
Cleaning the Pre-Motor Filter
Find replacement filters at
BISSELL.com
.
24h
1.
Press the tank release
button and pull out to remove
dirt tank.
2.
Remove carbon and foam
filter from lid.
3.
Hand wash in warm water
and rinse well; mild detergent
may be used if desired. Let dry
completely before reinstalling.
4.
Reinstall filters. The carbon
filter should be on top of the
foam filter.
5.
Return tank back on
vacuum and press firmly until
it clicks into place.
WARNING
»
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or
troubleshooting checks.
»
Do not operate vacuum with damp or wet filters or without all filters in place.
Maintaining the TurboEraser® Tool
For more helpful maintenance tips, check out
support.BISSELL.com
.
1.
Twist gray collar counter-
clockwise, until slot appears,
then separate faceplate.
2.
Remove brush roll, belt
and paddle wheel. Inspect
for damages and replace if
necessary.
3.
To reassemble, align two
clips on each end of paddle
wheel with belt on and pop
back into place. Place brush
roll with belt back in. Faceplate
will not close properly if all
parts are not aligned correctly.
