Power On & Settings
Turn the dial on the foot of the vacuum to the
desired setting. If the dial is difficult to turn, tilt the
vacuum back slightly to take the weight off the foot
while turning.
Press the recline
pedal and pull
handle back
towards you.
TIP:
For optimal carpet cleaning performance, adjust to the lowest practical setting. If
your vacuum is difficult to push, adjust to the next higher setting.
Lowest setting
– For low pile carpet or bare floors.
To pick up debris, it may be
necessary to move up one setting.
Medium setting
– For medium pile carpet.
Highest setting
– For high pile and most shag carpet.
WARNING
To reduce the risk of injury from moving parts while the
vacuum is turned on, always move the vacuum via the rolling wheels by using the
upper handle at the back of the vacuum. Do not carry the vacuum while it is running.
Always place vacuum on floor with handle in upright position when using tools.
NOTE:
Rotating Floor Brush continues to rotate while tools are in use. Never place fingers
under the vacuum when it is running. Never place Powerfoot on furniture or uneven
surfaces. Do not place vacuum close enough to objects to pull into rotating brush.
www.BISSELL.com
6
1
3
2
Press the red power
button with your
foot to turn the
vacuum ON and
once again to turn
your vacuum OFF .
WARNING
To reduce the risk of electric shock, turn power switch off and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
Press the tank release button and pull
out to remove Dirt Tank.
After emptied,
place tank back
on vacuum and
press firmly until
you hear “click.”
Empty once Dirt Tank is full.
NOTE:
T
he Dirt Tank may be washed in warm water with a mild detergent. Make sure it
is completely dry before replacing.
Hold the Dirt Tank over a trash container.
Press the bottom release button to
empty. Once empty, close the lid.
Empty the Dirt Tank
1
2
3
4
Twist Cyclone left and pull down to
remove from tank.
Clean Cyclone with warm water and mild
detergent. Let Cyclone dry completely
before replacing. To replace, fit into place
and twist to the right.
5
6
www.BISSELL.com
7
click
NOTE:
Certain carpets and low humidity conditions may generate small static
discharges. Static discharges are harmless and are not associated in any way with the
main power supply.
Automatic Cord Rewind
When you finish using your vacuum,
unplug it from the outlet. Hold onto
the plug and press the automatic cord
rewind button until it’s fully retracted.
If the cord doesn’t fully retract on the
first try, pull a little bit of cord out and
press the rewind button again.
To plug your vacuum in, gently pull the
cord out of the automatic cord rewind
and stop at the yellow mark on the
cord. Do not pull past the red mark.
Once you have the desired amount of
cord, plug it into the outlet.
1
2
