w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
perations
10
Getting ready to wet clean
NOTE: Remove tool caddy if
in place.
1.
attach the desired wet cleaning tool to
end of wand or grip.
2.
open the Quick Release™ hose door
and select “Wet clean” with the
mode selector.
3.
Place the clean solution tank on a
flat surface.
4.
fill the solution tank by first unscrewing
the measuring cap. always use genuine
bissell 2X formulas to maximize cleaning
and for the safety of your machine. fill
tank to fill line with hot tap water. add
two full measuring caps of formula.
screw measuring cap tightly back onto
the solution tank.
5.
Place the solution tank back in
the machine.
6.
make sure the float is in place. to install,
slide float into the channel located on
"fill line" side of the collection tank.
there is only one way to properly
install the float.
7.
Plug into a proper outlet and press the
on/off, wet clean and heater (if desired)
buttons down into the on position.
NOTE: Allow one minute for
the built-in heater to warm up
before cleaning. The Big Green
Complete will be fully warmed
and will provide optimal
performance after one minute
in the heater ON position.
Tip:
move furniture to another
area if cleaning an entire
room.
2
4
5
