www.BISSELL.com
www.BISSELL.com
9
8
WARNING
Do not operate vacuum with damp or wet filters, as well as without filters or the Dirt Tank in
place. Allow components to dry before reassembling the Dirt Tank.
To access filter, turn top
of tank counter-clockwise
and pull up to separate.
Remove foam filter. Hand
wash in warm water; mild
detergent may be used if
desired. Rinse well and air
dry thoroughly. Replace
filter if necessary.
Filter
Make sure the filter is
completely dry before
placing it back into the
tank top.
Press tank release button
and remove Dirt Tank.
1
2
3
4
5
6
Return the
tank’s top,
aligning
tabs and
twisting
clockwise
to lock.
Return tank, pressing
firmly until you hear
a “click.”
Pull brush roll straight out
and slide belt off.
Inspect brush roll by placing
it on its end and spin. The
brush roll should spin freely,
multiple times by one flick.
If it doesn’t, replace brush
roll. Inspect belt, replace if it
appears damaged.
Check Brush & Belt
Place belt back on motor gear. Pull belt over the
brush roll and place back in. Position the brush roll
end opposite of the belt to line up with tab. The
end closest to the belt will slide in the tab without
needing any rotation.
Unplug vacuum, turn
over, and unscrew 5 silver
Phillips-head screws and
remove bottom cover.
1
3
4
5
Re-attach bottom replacing
the 5 screws. Spin the brush
once by hand to self-center
the belt.
In Step 1 and 5, you will need a
Phillips-head screwdriver.
2
