5
Assembly
1.
Connect hose to vacuum by inserting hose
connector on the end of the hose into the suction
inlet. Make sure the hose is positioned so the tabs
on the hose connector line up with the notches
on the suction inlet.
2.
Connect hose handle to the end of the
extention wand and twist slightly to tighten.
3.
Connect floor nozzle to the end of the
extension wand and twist slightly to tighten.
4.
Once assembled, you can store your
vacuum by inserting the storage clip (located on
the back of the floor nozzle) into the storage slot
on the rear of the vacuum.
Colors may vary from models shown.
Automatic cord rewind
Your vacuum is equipped with an automatic
cord rewind. When cleaning is finished, press
the power button OFF and grasp the plug to
disconnect from the electrical outlet. Hold
the plug and press the automatic cord rewind
button to rewind the cord automatically.
Power button
Turn the power ON or OFF by pressing
lightly downward on the power button ( ).
Special tools
Your BISSELL vacuum is not only a powerful
carpet and rug vacuum cleaner, it’s also a
versatile bare floor and above floor vacuum
cleaner when you select one of the special tools.
Floor nozzle
Use to vacuum carpets, rugs and bare floors.
Swivel head turns to get into tight spaces and
fits under cabinets.
1.
To vacuum carpets and rugs, push the brush
switch to the carpet position
. This will
pull the brushes up into the floor nozzle.
2.
To vacuum bare floors, push the brush switch
to the bare floor position
. This will extend
the brus hes down from the floor nozzle.
WARNING
Do not operate vacuum with damp or wet filters
or without all filters in place first.
www.BISSELL.com
1.
3.
1.
4.
3.
2.
Operations
